Skip to main content
tapwater
England and Wales average 9.2

Tap water in BS1, Bristol, City ofToo few tap tests to call it.Hard.

Supplied by Bristol Water. 8 substances, latest on 25 September 2017. These are river and groundwater samples near BS1, not tests of treated tap water, so treat the score as a rough guide.

8.2 / 10

The tank is as full as the score. The specks are the minerals that make water hard.

What to do about it

Hard water: compare softener quotes

At 205 mg/L a softener is the only thing that stops limescale. Filters do not soften water.

It pays for itself in most homes at this hardness, through a boiler that stays efficient and appliances that last.

ZeroWater 10-Cup Jug

ZeroWater 10-Cup Jug

£40typical price

Households concerned about PFAS and heavy metals

Waterdrop 10UA Under Sink

Waterdrop 10UA Under Sink

£70typical price

High-volume under-sink filtration without RO complexity

We earn a commission if you buy through these links, at no extra cost to you. It never changes which product we put first. How we make money

Hear about it if BS1’s water changes

We check for supply incidents every fifteen minutes. If one affects BS1, you get an email the same day. You also get five short emails about your water over the first month.

Want this as a document?

Every result, the limits, hardness and what to do, as a PDF to keep with the house papers or send to a buyer or landlord. £19.99.

See the full report for BS1

What's in a glass of BS1 water

Every bubble is a substance the lab measured. The higher it floats, the closer it came to its legal limit, the dashed line at the top.

Ammonia came closest to a limit, at 28% of it. 2 of 3 substances used under a quarter of theirs.

0%25%50%75%limitLegal limitNitrate: 5.16 mg/L, 10% of the 50 mg/L limitNitrate10%Nitrite: 0.0729 mg/L, 15% of the 0.5 mg/L limitNitrite15%Ammonia: 0.14 mg/L, 28% of the 0.5 mg/L limitAmmonia28%
  1. Ammonia28%
  2. Nitrite15%
  3. Nitrate10%
  • pH 7.86 pH
  • Temperature 16.6 °C
  • Conductivity 890 µS/cm
  • Phosphate 0.349 mg/L
  • Dissolved Oxygen 7.35 mg/L
All 8 results as a table
SubstanceResultLegal limitShare of limit
pH7.86 pHNo legal limit–
Temperature16.6 °CNo legal limit–
Conductivity890 µS/cmNo legal limit–
Ammonia0.14 mg/L0.5 mg/L
28%
Nitrate5.16 mg/L50 mg/L
10%
Nitrite0.0729 mg/L0.5 mg/L
15%
Phosphate0.349 mg/LNo legal limit–
Dissolved Oxygen7.35 mg/LNo legal limit–

205mg of limescale minerals in every litre

This is the water that furs up kettles

Hard on the UK scale. It is fine to drink. It is hard on boilers, showers, skin and anything that heats water, and a jug or tap filter will not change that.

Soft400 mg/L

Over 200 mg/L, the building regulations guidance for England counts this as a hard water area: a new combination boiler or water heater should have limescale protection. The 200 ppm rule

Softener quotes for BS1

Leave your details and we will email you when we can match you with installers who cover BS1. No obligation.

A fitted softener typically costs £1,195 to £2,900. Prices by brand, with sources. Request a free assessment and we'll come back to you with local installer options for your area.

BS1— auto-detected from your search

100%

free, no obligation

shared only with your consent

Outside your tap

Your river is the Frome (Brist) - Bradley Bk to conf Floating Hbr, rated moderate

The Environment Agency rated the Frome (Brist) - Bradley Bk to conf Floating Hbr as moderate for ecological health in its 2025 assessment, meaning the river is noticeably changed by pollution or engineering. It is held back by organic pollution (bod) and phosphate. It fails the chemical test, as every river, estuary and stretch of coast in England does, because of long-lasting pollutants such as mercury, PFOS (a forever chemical) and old flame retardants.

None of this is a test of your tap water. Environment Agency record · River health across England

Within 10 km

179

forever-chemical detections in nearby rivers and groundwater

At 5 sites. The highest was PFOS at 0.023 µg/L, at Eastville Lake Inlet, 3.9 km away, in July 2023. These are river and borehole samples, not tests of your tap water.

Every PFAS sample around Bristol · Which filters remove PFAS · PFAS explained

BS1 in short

Tap water in BS1 (Bristol, City of) is supplied by Bristol Water. Bristol Water publishes no tap-water test results for this area, so the score of 8.2 out of 10 comes from 8 substances measured in rivers and groundwater nearby, not from the tap. Treat it as background. The hardness figure, 205 mg/L, is Bristol Water's own for this district. The latest sample is from 25 September 2017.

  • The newest sample here is from September 2017That is over 9 years old, so treat this page as a record of past results rather than today's tap water.
  • Hard water at 205 mg/LHard starts at 180 mg/L, the point where a softener begins to pay for itself. Limescale will build up in BS1. How hardness is measured
  • 8th cleanest of 13 areas tested in BristolSquarely mid-table for Bristol, between BS10 on 9.1 and BS8 on 8.2. Every area in Bristol

Questions about BS1 water

Is BS1 tap water safe to drink?

Based on the latest tests, BS1 (Bristol, City of) water scores 8.2/10, which is safe. 0 of 8 tested contaminants exceeded recommended levels. Water is supplied by Bristol Water.

What contaminants are in BS1 water?

We tested 8 contaminants in BS1 water. None exceeded recommended safe levels. PFAS (forever chemicals) were also measured in rivers and groundwater within 10 km, though not in the tap-water tests themselves.

Who supplies water in BS1?

BS1 (Bristol, City of) is supplied by Bristol Water. You can view their full profile and compliance data on our supplier page.

Is BS1 water hard or soft?

Water in BS1 (Bristol, City of) has a hardness of 205 mg/L CaCO3, which is classified as hard. Hard water can cause limescale buildup. A water softener or filter jug may help.

Should I use a water filter in BS1?

BS1 water scored 8.2/10 with no contaminants above recommended levels. A filter is optional but can improve taste, especially if you notice a chlorine flavour. See our filter recommendations for your area.

Are there PFAS forever chemicals in BS1 water?

The tap-water tests we hold for BS1 do not include a PFAS result. Environment Agency monitoring found PFAS in 179 river and groundwater samples from 5 sites within 10 km of BS1, the highest being PFOS at 0.023 µg/L about 3.9 km away. These are environmental samples, not tests of tap water. The UK currently has no legal limit for PFAS in drinking water; the Drinking Water Inspectorate uses a 0.1 µg/L guideline for individual compounds. Reverse osmosis filters can reduce PFAS levels.

How clean is the river near BS1?

The Environment Agency rated the Frome (Brist) - Bradley Bk to conf Floating Hbr as moderate for ecological health in its 2025 assessment, meaning the river is noticeably changed by pollution or engineering. It is held back by organic pollution (bod) and phosphate. It fails the chemical test, as every river, estuary and stretch of coast in England does, because of long-lasting pollutants such as mercury, PFOS (a forever chemical) and old flame retardants. This is a rating of the river, not of tap water in BS1, which is treated before it reaches homes.